Weird outline around faces when doing Lora inpainting

Tagged: ,

Viewing 1 reply thread
  • Author
    Posts
    • March 11, 2024 at 5:08 pm #12965
      Ian JonesIan Jones
      Participant

        I built a few face Loras based on the advice on this site and had good results using A1111 to inpaint to existing photos. However, when I tried again recently I got unsightly outlines around the areas where I drew a mask. I don’t think this happened before and I’m not sure what I’ve done wrong.

        Is there any way of removing these? What are the best settings for doing this kind of face swap Lora process?

        I do have adetailer and controlnet in there but this happens where I have them enabled or not, and whether I have denoising set to 0.7 or 1 (below that just produces a blur).

         

      • March 12, 2024 at 7:37 am #12979
        AvatarAndrew
        Keymaster

          Hi! I don’t recall seeing this artifact. You can try the new soft inpainting feature in A1111. Increase mask blur to 20 or more. You can use high denoising strength.

          (tutorial coming soon)

          • This reply was modified 8 months, 2 weeks ago by AvatarAndrew.
      • Author
        Posts
      Viewing 1 reply thread
      • You must be logged in to reply to this topic.